yucklys / polybar-nord-theme Goto Github PK

About polybar ttf-awesome-font, they are selected from gucharmap(字符映射表)

All of them will be displayed normally, but only the first and the second are displayed in fact.

It's the font config:

I have installed the awesome font

And they are really in the fc-list:

I don't know how to fix it, and I hava searched a lot of solutions but they are not worked.
Thanks for your reply ahead of time!

The bar size is very large after running ./launch

Getting some errors when I run ./launch.sh dark

error: Failed to restack bar window (x1)
error: tray: Failed to put tray above 0x0a00001 in the stack (XCB_MATCH (8)) (x1)
error: module/mpd: Connection refused (x infinity)

Not sure what I did wrong.

While running ./launch.sh

iddos@iddo-pc polybar $ ./launch.sh dark
Bars launched...
error: Monitor "eDP-1" not found or disconnected
error: Monitor "eDP-1" not found or disconnected```

I have 2 monitors, might be the cause of the problem, I hope you guys can help me out here

error: Disabling module "daily-poem" (reason: Inter-process messaging needs to be enabled)

It would a great help if u provide the wallpaper with that.

i followed the installation instructions but don't know what went wrong, I have this weird output:

I am using i3-wm on debian linux.

一直都是好好的，仅仅是更新系统。

$ sh .config/polybar/launch.sh
Bars launched...
error: Disabling module "daily-poem" (reason: Inter-process messaging needs to be enabled)
$

It says to set systray-top and bottom one to none and the other left/center/right and viceversa. But when I set it to right on top bar and none on bottom bar I get that weird black background

for people having an intel graphics card or a hybrid the backlight is controlled by the intel_backlight module located at /sys/class/backlight/intel_backlight/

fix :

[module/backlight]
type = internal/backlight
card = intel_backlight #replaced xbacklight to intel_backlight
enable-scroll = true

I don't know where to adjust the temperature module to take effect. It never shows up. And your temperature module link has failed.