How can I set the blockade rate at the start of the simulation? Is it in some .cfg file on config directory? about rcrs-server HOT 2 CLOSED

Dear @jpfsilvaa ,
You cannot set explicitly the amount of blockades, but you can change the Collapse settings to achieve what you are expecting. Below you find the list of parameters in the collapse.cfg file that allows you to deal with the number of blockades in the roads.
collapse.create-road-blockages # create blockade or not
collapse.floor-height # It will effect the number of blockade do you want.
collapse.wall-extent.min # It will effect the number of blockade do you want.
collapse.wall-extent.max # It will effect the number of blockade do you want.

To change the clearing rate, please refer to the followning parameters in the clear.cfg file
clear.repair.rate # Rate of clearing a road
clear.repair.distance # Distance of the clearing operation
clear.repair.rad # Width of clearing radius

Note that these configuration files are located by default in the boot/config directory, but you may specify other location when starting the simulator.

If you need further information, please us know.
Luis Gustavo Nardin

from rcrs-server.

I was trying to change this parameters but I wasn't specifying other location to the directory... Now it worked!

I'm going to continue my tests now, and if I need, I will ask you something else. Thank you!
João Paulo Francisco da Silva

from rcrs-server.