na1pir / as3935_esp8266_iot Goto Github PK

only even web gui buttons for adjusting cunning capacitors work.

it would be nice if we could save settings to flash;
-1 default settings button
-couple different profiles for different settings so if we use device in multiple locations.
-loading last used settings on boot

esp8266 can't drive inductive load directly, nor can it drive specified opto-transistor

it would be nice if we would have printout for disturbers and noise level to high interrupts
and settings to disable disturbers

probably something wrong with gpio settings

you could use websockets for updating distance, last interrupts, current register values,...

lco calibration doesn't work there must be something wrong with spi protocol or maybe with delays.

SREJ settings should have 4 bit not 3 bit values.
problem is in webpage

you could add some sort of visual feedback for certain danger level and device state in form of blinkenlights :)

you could add over the air updates instead always using uart cable

This is probably because of interrupts won't fire, so we are not switching between stages like software design intended (to switch between stages). So when we fix interrupts all should be well.
I should recheck all stages an maybe add intermediate stages better called pending.