BOB design guidlines about linuxcnc-rio HOT 3 CLOSED

small drivers without any protection works , but no good solution :)

if i build another board, i will add an ethernet adapter and differential inputs for encoders

from linuxcnc-rio.

That's exactly how I did it with the tango board:
https://github.com/multigcs/LinuxCNC-RIO/tree/main/configs/Tangoboard

from linuxcnc-rio.

Yes, I was using this board design as a reference when writing this message. Are my assumptions of connecting the switches and smaller stepper motor drivers directly to FPGA without any protection correct? What other recommendations on BOB design do you have?

from linuxcnc-rio.