mattairtech / samd-msd-bootloader Goto Github PK

Hi,
Is this bootloader compatible with a standard Arduino Zero, or M0/M0 Pro board, without change?

Hi,
Thank you for this bootloader! I am trying to make use of a push button located on PA28 pin and a TX-LED located on PA27. As per your bootloader the button needs to be on PA27.
I am unable to re-compile the bootloader. Is it possible for some help or guidance on the same?

I keep getting error while making:

process_begin: CreateProcess(NULL, uname, ...) failed.
process_begin: CreateProcess(NULL, uname, ...) failed.
process_begin: CreateProcess(NULL, uname, ...) failed.
process_begin: CreateProcess(NULL, uname, ...) failed.
make: *** No rule to make target `SAMD-MSD-Bootloader/main.o', needed by `msd_bootloader_samd21e18a_flash.elf'.  Stop.

and

process_begin: CreateProcess(NULL, uname, ...) failed.
process_begin: CreateProcess(NULL, uname, ...) failed.
process_begin: CreateProcess(NULL, uname, ...) failed.
process_begin: CreateProcess(NULL, uname, ...) failed.
make: *** No rule to make target `/xdk-asf-3.51.0/sam0/utils/linker_scripts/samd21/gcc/samd21e18a_flash.ld', needed by `msd_bootloader_samd21e18a_flash.elf'.  Stop.

I would like to use a MSD Bootloader with your new SAMD51 boards ?
Is it planned that you update this code for using with SAMD51 ?

Is it possible to make a MSD-CDC composit bootloader ? It will be great for noobs like us. I'm being curious after seeing a few composit bootloader on STM32

I would like to use your project as a starting point for a bootloader compatible with Xplained Pro board from Atmel. I'm going to use Atmel Studio (Windows OS) as IDE.

Any suggestions. I understood your project was compiled in Linux OS. However the gcc toolchain should be the same.

In Windows, I couldn't find the source code files of ASF. They are automatically imported in your project during ASF wizard. I understood, in Linux ASF installs source code directly.

I have loaded the bootloader into a arduino m0 and when i use pin D3 to low state and press and release reset button it shows up in my pc.
but when i write the new bin file to it and reset the program does not execute.

I saw that the DFLL reference clock is set to 8MHz, but the maximum is 33kHz and so the DFLL will not work in closed loop mode (it will not lock).
Datasheet -> Maximum Peripheral Clock Frequencies -> GCLK_DFLL48M_REF