ROS package providing simultaneous teleoperation of a custom micro-manipulator and a Universal Robots UR5e robotic arm via a 3D Systems Touch haptic stylus.
Additional dependencies and their installation instructions can be found in these repositories:
https://github.com/LMBScott/motor_angles_msg/
https://github.com/LMBScott/Serial_Control/
- Install Ubuntu 20.04 LTS
- Apply a patch to install a real-time kernel on your Linux system. The exact version used to develop the project was 5.15.96-rt61. Instructions can be found here.
- Install ROS Noetic.
- Install catkin_tools.
- Create a catkin workspace.
cd ~
mkdir catkin_ws && cd catkin_ws
-
Install the Universal Robots ROS driver in your catkin workspace and follow its setup instructions up to the end of extracting calibration information.
-
Install the Geomagic Touch driver. Note: The installation instructions on the GitHub page are outdated, working instructions as of February 2023 are:
- Install the driver's dependencies:
sudo apt-get install --no-install-recommends freeglut3-dev g++ libdrm-dev\ libexpat1-dev libglw1-mesa libglw1-mesa-dev libmotif-dev libncurses5-dev\ libraw1394-dev libx11-dev libxdamage-dev libxext-dev libxt-dev libxxf86vm-dev\ tcsh unzip x11proto-dri2-dev x11proto-gl-dev
- Install the OpenHaptics SDK. If the page is unavailable, search for "openhaptics linux sdk" and install the most recent version available.
- Install the compatible Touch driver version from the same page.
- Follow the installation instructions. If the page is unavailable, follow the instructions found on the most recent version of the openhaptics Linux SDK install page used in step 2.
- For a 64-bit system, create symbolic links by executing the following commands:
sudo ln -s /usr/lib/x86_64-linux-gnu/libraw1394.so.11.0.1 /usr/lib/libraw1394.so.8 sudo ln -s /usr/lib64/libPHANToMIO.so.4.3 /usr/lib/libPHANToMIO.so.4 sudo ln -s /usr/lib64/libHD.so.3.0.0 /usr/lib/libHD.so.3.0 sudo ln -s /usr/lib64/libHL.so.3.0.0 /usr/lib/libHL.so.3.0
Note: Run
./Touch_Setup
and./Touch_Diagnostic
found in the touch driver directory, with the Touch device connected, to verify that Touch communication is functional. -
Clone this repository into your catkin workspace.
-
Build and source your catkin workspace using
catkin build
.
Thanks to Mustafa Sevinc for writing the original installation instructions.
-
Start ROS:
roscore
-
Add permissions for touch USB device:
sudo chmod 777 /dev/ttyACM0
-
Start Touch Driver:
roslaunch omni_common omni_state.launch
-
Start driver:
roslaunch ur_robot_driver ur5e_bringup.launch robot_ip:=192.168.0.100 kinematics_config:=/home/lachlan/lab_ur5e_1_calibration.yaml
-
Start LS_ROS_CONTROL program on UR5e Teach Pendant
-
Start control node:
rosrun ls_thesis ur5e_control
-
Add permissions for Arduino device:
sudo chmod 777 /dev/ttyACM1
-
Start serial node:
rosrun rosserial_python serial_node.py /dev/ttyACM1
-
Start control node:
rosrun ls_thesis micro_module_control
NOTE: Be sure to manually disable power to servo motors via the switch on the micro module before unplugging the control USB cable