zruncho3d / boxzero Goto Github PK

Prusaslicer ver. 2.4.2, 0.2mm layer height, Layer 283 (Z 56.6) there's a little floaty bit where the screw holes begin bridging together.

I think if you either size-up or size-down those holes, you could get that very small problem to slice correctly. Definitely not a problem if a little blob sticks to a wall, but I figured I'd let you know. :)

Reported by DrawnToLife on Discord:

sorry - now that I've done most of the conversion (A/B blocks built, extrusions swapped out, just putting the gantry back together now but idlers and what not are in place), let me clarify

the original A/B blocks use all M3x35, so you actually need 6 new new M3x30 screws to build the new A/B blocks, not just 2 (b/c you can't salvage any screws from any of the other conversion steps)

Whilst slicing, it is shown that the bridges for the slot holes are not on a flat plane, which causes issues when bridging and printing.
Nothing that can't be fixed with a quick snip or even a minor pull of the plastic, but do expect a tiny amount of clean-up.

The holes needs to be moved up by 0.865mm.

It's honestly not a big issue as you still end up with all the right printed parts, it just caused me a bit of confusion when I went to slice them. It could maybe cause someone to print the wrong part if they have to reprint one of them.

If you could publish the CAD files for the upper mini frame blocks it would be hugely appreciated.
thanks in advance!