yo6nam / mmdvm_pog Goto Github PK

This project is a hardware for the Multi-Mode Digital Voice Modem (MMDVM). Instead of depending on MCU development boards (like Arduino, STM Discovery, etc.), this design contains a microcontroller itself, so no additional stuff is required. This project is based on SQ6POG's idea, and hence its name.

The board contains STM32F105RBT MCU, two active low-pass filters: for ADC and DAC. Additionally there is a place for an optional TCXO with a buffer circuitry and LED indicators.

The PCB is prepared to be populated in two configurations listed below.

The board is populated with FT230XS USB-to-UART converter and 3.3V LDO

This configuration is almost the same as previous, but with RPi connector and without USB-to-UART converter and LDO.

You can get the firmware from MMDVM github. The firmware can be built with the GNU ARM toolchain. An additional requirement is the STM32CubeF1 package, which can be found at STMicroelectronics website. Path to the CMSIS directory of the extrected package should be adjusted in the Makefile.CMSIS as CMSISDIR definition. Also uncomment these defines in the Config.h file:

// For the SQ6POG board
#define STM32F1_POG

to enable MMDVM_pog board support,

// Pass RSSI information to the host
#define SEND_RSSI_DATA

to enable RSSI feature,

// Use pins to output the current mode
#define ARDUINO_MODE_PINS

to enable mode LEDs output,

// For 19.2 MHz
#define EXTERNAL_OSC 19200000

if you want to use external TCXO.

Be sure that defines regarding other boards are commented.

Finally to build the firmware simply run:

make -f Makefile.CMSIS

To program the device with SWD, run:

make -f Makefile.CMSIS program

(you will need openocd software and ST-LINK programmer).

If you don't have ST-LINK and want to use bootloader, then short JP1 jumper and run:

make -f Makefile.CMSIS program_bl

(you will need stm32flash software; serial port can be selected in the Makefile)

This project was designed using gEDA software. In order to modify the schematic you will need my library of symbols/footprints, which is available here. The library is also attached to this repository as a submodule (geda-sym). To get it contents after cloning the repository run git submodule update --init. Update of the PCB is done in the root directory with this command:

gsch2pcb mmdvm_pog.prj

Postscript and pdf export of PCB is done with:

./pcb_export mmdvm_pog.pcb

The simulation of the filter (sim directory) was performed in ngspice and the graphical plot output was generated using gnuplot. To run the simulation use the script provided:

./simulate filter.sch

This project is licensed under the CC-BY-NC-SA (Creative Commons - Attribution, Noncommercial, Share Alike) license and is intended for amateur and educational use only.

MMDVM software is licenced under the GPL v2 and is intended for amateur and educational use only. Use of this software for commercial purposes is strictly forbidden.