vzense / vzense_sdk_windows Goto Github PK

I have two DCAM710s and both only show one depth mode (0) available. I've tried in the Config tool, but there is only 0 in the list of modes. Any advice?

Hi,
Currently, there are 3 different range modes calibrated for the Tof Camera (0.35-1.4m, 0.5-2.5m, 0.8-4m)
Is it possible to add a new range : 0.15m and 0.6m ?
In that way, the camera could be used to make 3D scanning of small and medium objects.

Thanks.

Hello. I would like to use 2 cameras 550p together, but I don't know how to connect one camera to another. Could you send a wiring diagram?

i followed the 08PointCloudCaptureAndSave example.
now i want to write the same code for saving the IR and the RGB images but i can not find the commands similar to PointCloudWriter and other commands needed for saving.
also, when i check FrameReady.RGB i do not get 1, all the time i get 0. when checking FrameReady.depth or FrameReady.IR i get 1 .

if there is a sample code for IRCaptureAndSave and/or RGBCaptureAndSave or a list of commands it also can help
thank you

I have tried to open DCAM710 with camera application on Windows 10 but it's not work well.
I want to integrate it in C# Project but it couldn't work.
I also run VZenseUtool to upgrade the lasted firmware version but the result remains unchanged.
Please tell me know how to control this camera in C#?

Hi,

could you please explain the possible depth modes. I could only find estimated ranges for the modes PsNearRange (150 - 1500 mm), PsMidRange (500 - 2800 mm) and PsFarRange (800 - 4400 mm). What is the difference to the X and XX modes? And which of the modes is actually available on the DCAM710?

Extracted from Vzense_enums_710.h:

typedef enum {
	PsUnknown = -1,
	PsNearRange = 0,               
	PsMidRange = 1,                
	PsFarRange = 2,                
	PsXNearRange = 3,              
	PsXMidRange = 4,               
	PsXFarRange = 5,               
	PsXXNearRange = 6,             
	PsXXMidRange = 7,              
	PsXXFarRange = 8               
}PsDepthRange;

你好，

经过我们验证，DCAM550P一上电就会点亮光源，通过UTool关闭设备后，光源仍不关闭。
在B41以及最新的B42固件版本上均是如此。

请问这是BUG还是有其他原因？