undergroundfpv / opentx-nv14-ufpv Goto Github PK

On initial model creation, the home screen displays the name of the model. However, if you edit the screen panels it goes away and there is no way to recover it. Also, there are no telemetry screens available.

All the other points are selectable, last point cannot be selected. the next and previous buttons skip it.

MultiModule support is missing. See https://github.com/chevyhu/Flysky-OpenTX-Test-Branch/issues/5
Not sure which project is the right place for this issue.

Using the mixer or input screen to modify channels you are unable to use a higher weight than 100%. This makes it impossible to send rssi back via a channel and have it accurately report via an osd.

When trying to name a channel and I press the symbol key on virtual keyboard, the device just powers off.
Using buld opentx-NV14-2.2.2 (01c2292) (new alphabetic keyboard)

No telemetry from flysky receiver. (Rssi)

Tested on :
Flit 10
Flit 14
X8b
X6b (no battery voltage)

When you select ASK, I would assume this means when you plug in the USB cable either the Nirvana or the PC should ask which type of connection do you want (i.e. SD Card, Joystick, Serial, etc.)
But right now it does nothing at all, in fact you get a USB error when trying to use this.

Whatever is set on config screen, there is never pre model activation warning

The crossfire binding button will cause the top to go in to "Saving" which will freeze the button and not bind. Will occasionally pop up the update button before going in to "saving" and freeze. Was able to make it work by trying multiple times and tapping the button quickly to get through to the update button and confirm before it locks up. Went through update fine. Display button froze at 66% but actually finished updating and was able to back out and work fine.

When setting up a logical switch based on a telemetry voltage (VFAS or A1 - Total Voltage or Average Cell Voltage), using the A < X or A > X switch, it seems to be impossible to set the checked value above 2.5V.

In the September firmware this was working correctly, and I could set the switch on A1 to 3.2V so it worked as a voltage warning, but now won't trigger until the voltage is overly low at 2.5V.

In special functions, when I set SWEup to Reset, I need to go out and back in to determine what to reset.
List of items displayed contains 4 timers, and then entries with garbage memory contents. So wrong index / length is used here. Array out of bounds.

When you set down position as a condition to a virtual Switch, it activate also on middle position

You can put spaces on model names, but if you do so, there is no way to revert it.

I created a logical switch a<x V1=ERxB V2=10.8 AND switch L04
I can see that L04 is set telemetry reports 1.6 volts, but this logical switch is not set.
I suspect the same happens with RSSI, but I'm not 100% sure.

the voltage delivered by the module bay is lower than spec for jr module it also doesn't power off when external module is turned off. The bay is still receiving ~3 volts of power while the radio is off

How to reproduce:

• Firmware version: 5e49bc4
• Have two models created
• Switch from one model to another

What happens:

• The emergency mode is (falsely) triggered

It seems that the commit a8e7e6a or 5e49bc4 introduced this problem.