therosyproject / pioneer Goto Github PK

In the RICK PCB the SD card module has CS pin connected to ESP8266-feather-huzzah pin 14. Unfortunately this is not working, this pin seems to a shared CLK pin.. very annoying. We should change it to pin 16. Working after testing on a protoboard.

The 2nd ADC should have label indicating Addr: 0x49 (not 40)

Currently enclosure box is a commercial junction box (e.g., Zulkit Junction Box ABS Plastic Dustproof Waterproof IP65 Electrical Boxes Hinged Shell Outdoor Universal Project Enclosure with 2 Cable Glands 5.9 x 3.9 x 2.8 inch (150x100x70mm)).

Start to work on a dedicated enclosure for indoor space.

We should remove the unused labels on the PAT PCB:

• 10 uF
• 4.7 uF
• R5K

We should add the following labels

1. Sheet "Controller Box V2", line 11 (see orange underline):

• there is a broken link for the Inductor 4.7uH SMD - 1206
• provide a precise or estimated unit cost (column I)

2. Both "Controller Box V2" and "Sensor Box":

• check that the values in column H are correct, in red the differences between column H and D.
• provide an estimated production cost per units and shipping cost (Controller Box V2: line 35-36, Sensor Box: line 16-17)

The RTC can be used instead of the ADC 0x49, NOT in place of the ADC 0x48, as for the latter case the BAT (5V) pin of the RTC would be connected to GND!

Fix: remove the 2 pins and labels for the RTC module.