This repository contains the simulations done using NI Multisim 14.1+. The files are ready to be opened from the said version of the software. Download NI Multisim Education Edition 14.0 using the below-mentioned instructions. It is a full featured software for learning circuit design.
sudo apt-get install git
git clone https://github.com/chilloutwithanas/AnasKhan-CrystalOscillatorDesign.git
Click here to download the NI Multisim into your system.
First install NI multisim from the above mentioned site or from your choice. After steps to draw and run schematic on NI multisim in windows are as follows:
- Extract the files to download
- Open NI Multisim 14.1 from start menu
- click on Launch Multisim
File -> New -> Open (Ctrl + O)
- Choose the respective
.cir
file and open it. - The required circuit will start getting placed in the open area along with connections.
- To open file whch is already created
File -> Open -> choose schematic file in .ms14 extension
- Go to
Simulate -> Analyses and simulation
- Choose required analysis and enter variables and choose parameters to be displayed .
- To run
Simulate -> Run
- Outputs are shown on simulation window.
- For spice netlist
Transfer -> Export SPICE Netlist -> Save
(save in.cir
extension)
The oscillator is an important block in electronic devices which work on the principle of oscillation. The oscillators can be designed from a wide range of well-known topologies. However, not all types of the oscillators can be integrated. The crystal oscillator is one of the oscillators which is impossible to integrate into CMOS technology.
- Anas Khan B.Tech Computer Science and Engineering, SRMIST, KTR [email protected]
- Kunal Gosh Director, VSD Corp. Pvt. Ltd. [email protected]
- Philipp Gühring Software Architect at LibreSilicon Association [email protected]
- Dr. Gaurav Trivedi
Co-Principal Investigator, EICT Academy,
and Associative Professor, EEE Department, IIT Guwahati [email protected]
Pull requests are welcome. For major changes, please open an issue first to discuss what you would like to change.
Please make sure to update tests as appropriate.