• Error no such partition entering rescue mode grub rescue is common after Ubuntu Linux is removed from dual boot PC or when the partition on which a Linux distro was installed is tampered with. The error occurs mainly out of a misconfigured bootloader or wrong active partition.

If you encounter the dreaded "No Such Partition" error and find yourself stuck in rescue mode, don't worry! Follow these steps to get your system back on track:

Start by listing all available partitions using the ls command:

ls

This will display a list of partitions similar to the following image:

on your case it would be grub rescue> instead of grub>

To identify the file type within a specific partition, use the following command:

ls (partition name)

Note: If you encounter a 'Filesystem is unknown' error, it means there's no operating system installed on that partition. Continue searching until you find a different output, as shown in the image below:

Once you've identified the partition you want to boot from, set it using the following commands. Adjust the partition name accordingly; use the commands:

set boot=(hd1,msdos5)
set prefix=(hd1,msdos5)/boot/grub
insmod normal

The setup should look like this:

If you encounter an error, redo it again as you double-check the partition name and ensure you've used the correct commands.

To complete the process, enter the following command:

normal

This should bring your system back to normal, and you should no longer see the "No Such Partition" error. If you still have issues, please go ahead and revisit the partition identification and setting steps.

You will need to boot into your Linux distro and use Ctrl + alt + t to open the terminal, then check Windows Partition: Confirm where your Windows is stored using commands like lsblk or fdisk -l. It might be /dev/sda1 or any other.

Update GRUB for Windows: Add a special Windows option in the /etc/grub.d/40_custom file. Here's an example:

menuentry "Windows 10" {
    insmod ntfs
    set root=(hd0,msdos5)
    chainloader +1
}

Replace (hd0,msdos5) with your Windows partition info.

Enable os-prober: In /etc/default/grub, make sure GRUB_DISABLE_OS_PROBER is set to false for automatic detection of bootable partitions.

Update GRUB: Run sudo update-grub to refresh the GRUB configuration.

Are you getting grub rescue every time you reboot your system? Fear not! Here's your escape plan in a few easy steps:

Open your Linux terminal with the command provided on option one then run the following commands:

sudo add-apt-repository ppa:yannubuntu/boot-repair
sudo apt-get update
sudo apt-get install -y boot-repair && boot-repair

a new window will open where you will be required to select your preferred repair option and then Patiently wait for the repair process to reach successful completion. Upon successful repair, you will witness the following confirmation:

To finalize the process, reboot your system using the following command:

sudo reboot

and you'll be done!

After these steps, you will be able to boot into your windows.

If you have questions or suggestions on improving the information on this page, you can always write to issues.