The board uses USB as the JTAG upload port. When printing serial port information on USB, CDC_ON_BOOT configuration needs to be turned on. If the port cannot be found when uploading the program or the USB has been used for other functions, the port does not appear. Please enter the upload mode manually.
- Press and hold the BOOT button when the power is off, the button is located behind the RST button.
- When the USB is connected, first press and hold the BOOT button, then click reset and then release the BOOT button
- In Arduino Preferences, on the Settings tab, enter the
https://raw.githubusercontent.com/espressif/arduino-esp32/gh-pages/package_esp32_index.json
URL in theAdditional boards manager URLs
input box. - Click OK and the software will install.
- Search for ESP32 in Tools โ Board Manager and install ESP32-Arduino SDK (version 2.0.3 or above)
- Copy everything from this repository lib folder to Arduino library folder (e.g.
C:\Users\YourName\Documents\Arduino\libraries
) - Select the correct settings in the Tools menu as shown below.
Setting | Value |
---|---|
Board | ESP32 S3 Dev Module |
USB CDC On Boot | Enabled |
CPU Frequency | 240MHz (WiFi) |
Core Debug Level | None |
USB DFU On Boot | Enabled |
Events Run On | Core 1 |
Flash Mode | QIO 80MHz |
Flash Size | 16MB (128Mb) |
JTAG Adapter | Integrated USB JTAG |
Arduino Runs On | Core 1 |
USB Firmware MSC On Boot | Disabled |
Partition Scheme | Huge APP (3MB No OTA/1MB SPIFFS) |
PSRAM | OPI PSRAM |
USB Mode | Hardware CDC and JTAG |
- PlatformIO plug-in installation: click on the extension on the left column โ search platformIO โ install the first plug-in
- Click Platforms โ Embedded โ search Espressif 32 in the input box โ select the corresponding firmware installation
-
Use board as delivered. Connect board to usb to computer without touching anything else. Upload the code. The code will start right after download and run. Unplug the board and connect to usb again. The board will not do anything.
-
Use board as delivered. Push down boot button. While boot button is pushed, connect usb to computer. Release boot button. Upload the code. The code will not start right after download. Nothing will happen. Unplug the board and connect to usb again.The board will now boot the code. Unplug the board from USB to computer and connect to other power source like LiPO battery. Again the board will start the code. The computer is not needed again.
New code can be loaded to the board by going to step 1 or 2. Both will still work.