Interactive pinout diagrams for microcontrollers and other electronic components.

• Arduino Uno (ATmega328P)
• Arduino Nano (ATmega328P)
• NodeMCU v2 (ESP8266)
• Raspberry Pi Zero 2 W (ARM Cortex-A53)

If you want to add support for a new device (board), please follow these steps:

1. Create a new file in the data/boards directory, named after the device (e.g. boardname.ts). Check the rules below for the file name.
2. Add the device to the data/boards.ts file.
3. Add required data to the new file (see the other files for examples) and make sure it exports the BoardType interface. The interface is defined in lib/interfaces/board.interface.ts.
4. Run npm run build to to check if the new board is valid.
5. Open a pull request.

The file name should be the same as the device name, but with the following changes:

• The spaces should be replaced with dashes (-).
• All non-alphanumeric characters should be omitted.
• All letters should be lowercase.
• The file name should be unique.
• The file name should not contain any spaces.
• The id of the board should be the same as the file name.
• The file extension should be .ts.

This project is licensed under the MIT License - see the LICENSE file for details.