Freepad is an open source Zigbee remote intended to be used to have a customizable keypad to control your smart home devices.
Read more here: https://modkam.ru/?p=1264

1. Single/double/tripple/quadriple/many_x/hold&release
2. Touchlink reset
3. ONOFF bind
4. Level control bind
5. Bindings configuration
6. Remote reset

1. Press and hold first button for 3-10 seconds(depends whter or not device is on a network), until device start flashing led
2. Wait, in case of successfull join, device will flash led 5 times
3. If join failed, device will flash led 3 times

Deprecated due to memory issues, you can use FREEPAD_ENABLE_TL macros if you want to compile with TL functionality

Should be already in dev branch (as of 19-05-2020)

By default remote works as custom swith, with multiple clicks, this behaiviout has own drawback. In order to detect multiple clicks, remote sends commands with 300ms delay. You can change this behaviour by cost of double/tripple/etc clicks. To do that you need to change

ZCL_CLUSTER_ID_GEN_ON_OFF_SWITCH_CONFIG cluster ATTRID_ON_OFF_SWITCH_TYPE attribute

Values are:

ON_OFF_SWITCH_TYPE_MOMENTARY (0) -> no delay, but no multiple clicks, only single

mosquitto_pub -t "zigbee2mqtt/FN/BUTTON_NUM/set/switch_type" -m '0'

ON_OFF_SWITCH_TYPE_MULTIFUNCTION (2) -> 300ms delay, full set of clicks

mosquitto_pub -t "zigbee2mqtt/FN/BUTTON_NUM/set/switch_type" -m '2'

By default command is TOGGLE, but you can change this behaviour

Change ZCL_CLUSTER_ID_GEN_ON_OFF_SWITCH_CONFIG clusters attribute ATTRID_ON_OFF_SWITCH_ACTIONS

ON_OFF_SWITCH_ACTIONS_ON

mosquitto_pub -t "zigbee2mqtt/FN/BUTTON_NUM/set/switch_actions" -m '0'

ON_OFF_SWITCH_ACTIONS_OFF

mosquitto_pub -t "zigbee2mqtt/FN/BUTTON_NUM/set/switch_actions" -m '1'

ON_OFF_SWITCH_ACTIONS_TOGGLE (default value)

mosquitto_pub -t "zigbee2mqtt/FN/BUTTON_NUM/set/switch_actions" -m '2'