lilypad_arduino_simple's Introduction

LilyPad Arduino Simple

LilyPad Arduino Simple Board (DEV-10274)

This LilyPad board is smaller than the LilyPad Main Board, with fewer pins. However, it does have a built-in power supply socket, and an on/off switch.

Repository Contents

/Hardware - All Eagle design files (.brd, .sch, .STL)
/Production - Test bed files and production panel files

License Information

The hardware is released under Creative Commons ShareAlike 4.0 International. The code is beerware; if you see me (or any other SparkFun employee) at the local, and you've found our code helpful, please buy us a round!

Distributed as-is; no warranty is given.

lilypad_arduino_simple's People

Contributors

Stargazers

Watchers

lilypad_arduino_simple's Issues

Checklist Review for v26 (protos)

Is proper attribution given to the original designer? [YES]
comment: the text objects for the designers and revisers and the version # should all be on the symbols layer
If net labels are used, are they the correct 'FLAG' type? [NO]
comment: Looks like your RXI and TXO flags (nets) on JP2 have gone missing - perhaps when you deleted test points. please reconnect/reroute
Are junction dots used for all 3-wire connections? [YES]
comment: un-necessary node on the 5V net (bottom left of sch)
Does every part have a NAME and VALUE (with proper prefix and no '$')? [NO]
comment: ATMEGA328 needs 'U1' and value
Is the FTDI connector oriented so the FTDI breakout can be slid on properly (IC side up, header side down)? [NO]
comment: needs nets and traces for TX RX routed/corrected
Is the direction of TX/RX serial connections correct? [NO]
comment: can't check yet until they are routed again
Does it pass SparkFun DRC? [NO]
comment: 11 errors still present but they are cool to approve
Is there a note for a board thickness other than 0.63 inch? [YES]
comment: should be on tdocu layer
Are measurements included for outer dimension and standoffs (Eagle layer 47)? [YES]
comment: the text object "dimension in inches" should also be on layer 47
Are all connectors labeled with their purpose? [NO]
comment: "I2C" on both A4 and A5 is helpful, but I think that they should be labeled "SDA" and "CLK" - this is our usual labeling of I2C lines, however I nkow lilypad is never usual

Recommend Projects