roelkroes / horusbinary_tracker Goto Github PK

As an additional feature, it would be nice to implement the small BME280 Temp/hum/press sensor using I2C.
The space in the Arduino pro mini, will surely be not enough for all data, but one of 3 would already make an asset.
And can then be implemented to send it also with the payload.

Thanks 73

Luke ON2ON

Maybe I missed it - are you setting the uBlox GPS into airborne mode?
If not, this tracker code will likely lose GPS lock above 18km altitude - not ideal!

Hi, i am trying to build the project.
I have no clue what could cause this, i did fill all settings in the settings.h
Could it be the arduino should be connected?

\HorusBinary_Tracker-main\ADC\FSK4_Mod.ino:12:20: error: 'PhysicalLayer' was not declared in this scope
int16_t fsk4_setup(PhysicalLayer* phy, float base, uint32_t shift, uint16_t rate){
^~~~~~~~~~~~~

\horusBinary_Tracker-main\ADC\FSK4_Mod.ino:12:35: error: 'phy' was not declared in this scope
int16_t fsk4_setup(PhysicalLayer* phy, float base, uint32_t shift, uint16_t rate){

Hum, maybe found the reason .... if no arduino connected the IDE want to assign ip ...

Connected pro mini

Darn error stays, does someone have any clue what could cause this error?