rnd-ash / w203-canbus Goto Github PK

Hello,
I am very interested in your project. I am trying to read the signal the can-bus sends to the factory alarm siren when the alarm goes off. i am trying to activate a relay when the alarm goes off. i already have an Arduino and mcp2515 controller but i cant find useful information about the BCM can bus signals.

I will unfortunately be putting this on hold for a bit...

I rebuilt my transmission (722.6) and during the process didn't put enough ATF in. That's all fixed now however the TCM is now in hard limp home mode.

During these difficult times, everywhere is shut, so I likely can't get it cleared using a dealer. So, I have a new project.

I have Xentry passthru on my laptop, however no adapter. Only my Arduino. So my new project will be to turn my Arduino into a J2534 adapter so Xentry can use it.

There are 2 new repos on my account for this project should you be interested. I will however come back to this project once that's fixed as I still have a lot planned for this!

Suggest fill in some details on hardware interfacing?

How do you get at the canbus?
What chipset are you using?

etc

Hello,

My friend bought a W209 with comand 2.0 navigation interface. We are looking for an integrated bluetooth a2dp solution which can work with cd-changer/aux input. Is your solution can be used with an IOS phone? How do you feed the audio line?

Hi Dear,
i tried to debug the android app using android studio but with no luck, i think because of the difference in verisons.
any body have an idea.
even the arduino code is not compatible with UNO, may you please advise if you used UNO or MEGA board.