[BUG] MK3.5 6.0.3 Firmware - Print not centered on bed. about prusa-firmware-buddy HOT 3 OPEN

I also have this issue. While upgrading to MK3.5 I changed from nylon lock to the new spacers for the heat bed.
Whether the old y-carriage in combination with new spacers cause this shift, or the new homing sequence set a different 0,0 position I don`t know. In #3851 they just limit the right boundaray -5mm for PINDA. Maybe it would be better to shift the whole origin more to the left.
Meantime I define offsets in PS:

from prusa-firmware-buddy.

Thanks for filing this. Would like to see this acknowledged/addressed as well

from prusa-firmware-buddy.

I understand why Prusa says it should not be perfectly centered in the prior issue, and frankly that is not my expectation. However, if it was closer to center on the build plate, I believe the PINDA probing off the edge issue would have likely never been a problem.

Frankly, I'm also disappointed they closed the prior issue, which initially was reported as the print not being centered, was changed to "PINDA not probing correctly" and then the issue closed with the release of 6.0.3, as I believe that fix is a bandaid for this larger problem.

It largely does not give me confidence the MK3.5 upgrade was worth it.

from prusa-firmware-buddy.