The PIC18F47Q10 features Timers with Gate Control. This example shows how to use the TMR1 configured in gate single pulse and toggle combined mode. It with sample a full period of a signal. A GPIO pin will be configured as input and it will be connected to a periodical signal.

• PIC18F-Q10 Family Product Page
• PIC18F47Q10 Data Sheet

• MPLAB® X IDE 5.30 or newer (microchip.com/mplab/mplab-x-ide)
• MPLAB® XC8 2.10 or a newer compiler (microchip.com/mplab/compilers)
• MPLAB® Code Configurator (MCC) 3.95.0 or newer (microchip.com/mplab/mplab-code-configurator)
• MPLAB® Code Configurator (MCC) Device Libraries PIC10 / PIC12 / PIC16 / PIC18 MCUs (microchip.com/mplab/mplab-code-configurator)
• Microchip PIC18F-Q Series Device Support (1.4.109) or newer (packs.download.microchip.com/)

• PIC18F47Q10 Curiosity Nano (DM182029)

The PIC18F47Q10 Curiosity Nano Development Board is used as the test platform.

The following configurations must be made for this project:

Run the code in debug mode. Pin RB5 is configured as digital input. A periodical signal needs to be applied to this pin. Set a breakpoint inside "TMR1_GATE_ISR()". The measured frequency will be stored in the variable called "value". The code will stop at the breakpoint when the signal period has ended.