Hi,
I have a VM running Quagga, latest version, simple config. When I use the 'load via telnet' option then the server only shows a 2 node map, with 1 link, rather than the whole map. It would appear that the command 'show ip ospf database network' doesn't show my entire network, but just the 2 nodes (p2p connection between them).

Is there some config option for Quagga to enable the command to show the whole network perhaps? Help!
(any getting started guide gratefully received!)

JOnty

Thanks for the great piece of software - but it does not work with point2point connections between routers.

So if interface command "ip ospf network point-to-point" is used to avoid DR/BDR election ramp up time it does not work.
Unfortunately.

What steps will reproduce the problem?
1. Open a file from zip.
2. Export/Save as NML
3. Try and load...

What is the expected output? What do you see instead?
It should load the project as it had been saved.  Instead, I get a blank/broken 
screen.  I can access all the menus and even switch my active project. The main 
screen of the *.nml project is just broken.

What version of the product are you using? On what operating system?
I am on Windows 7 using ospf3.0.5.jar

Please provide any additional information below.

Original issue reported on code.google.com by [email protected] on 3 Jun 2015 at 3:42

There is just a password option when you try to load data via telnet, There 
also should be an option to write a username. Can you please update it, your 
tool seems so good and useful. Keep the good work.

Original issue reported on code.google.com by [email protected] on 25 Mar 2014 at 7:37