A remote access IOT project communicating via bluetooth between an Arduino & Raspberry Pi

• Arduino & Supplies LINK:
  • Arduino Uno [alternate(s): arduino nano]
  • Ultrasonic Sensor [alternate(s): IR Range Finder]
  • Stepper Motor & Driver
  • Jumper Wires (male-to-female & female-to-female)
• Raspberry Pi:
  • Pi 3 B+ & Power Supply LINK [alternate(s): Pi 4, Pi Zero W]
  • 32GB Micro SD Card LINK (16GB may be enough, but for future scaling up 32GB or greater would be best)
• Raspberry Pi Camera LINK
• Ping Pong Ball LINK
• HC-05 Bluetooth Module LINK
• The Balance Beam

NOTE:: The balance beam will have to be hand crafted for now. When a tested design has been found/made it can be included in the list.

• Basic linux commands (i.e. cd, ls, mkdir, etc)
• Basic C/C++ understanding for arduino
• Basic circuit wiring understanding
• Intermediate Python
• Basic HTML

• PWM - Pulse Width Modulation for Stepper Motor Control EXPLAINED
• Bluetooth communication ARDUINO & HC-05 Raspberry PI
• Web Server Website/WebApp setup using apache2 TUTORIAL
• Front-End & Back-End Development
• PID - Proportional-Integral-Derivative Controller EXPLAINED