AIM:
To implement 4 bit synchronous up counter and validate functionality.
SOFTWARE REQUIRED:
Quartus prime
THEORY
4 bit synchronous UP Counter
If we enable each J-K flip-flop to toggle based on whether or not all preceding flip-flop outputs (Q) are “high,” we can obtain the same counting sequence as the asynchronous circuit without the ripple effect, since each flip-flop in this circuit will be clocked at exactly the same time:
Each flip-flop in this circuit will be clocked at exactly the same time. The result is a four-bit synchronous “up” counter. Each of the higher-order flip-flops are made ready to toggle (both J and K inputs “high”) if the Q outputs of all previous flip-flops are “high.” Otherwise, the J and K inputs for that flip-flop will both be “low,” placing it into the “latch” mode where it will maintain its present output state at the next clock pulse. Since the first (LSB) flip-flop needs to toggle at every clock pulse, its J and K inputs are connected to Vcc or Vdd, where they will be “high” all the time. The next flip-flop need only “recognize” that the first flip-flop’s Q output is high to be made ready to toggle, so no AND gate is needed. However, the remaining flip-flops should be made ready to toggle only when all lower-order output bits are “high,” thus the need for AND gates.
Procedure
/* write all the steps invloved */
PROGRAM
DEVOLOPED BY : S.NAVEEN
REGISTER NUMBER : 212223240106
module ex11(out,clk,rstn);
input clk,rstn;
output reg [3:0]out;
always @ (posedge clk)
begin
if(!rstn)
out<=0;
else
out <= out+1;
end
endmodule
RTL LOGIC UP COUNTER
TIMING DIAGRAM FOR IP COUNTER
TRUTH TABLE
RESULTS Hence a 4 bit synchronous up counter is implemented correctly