Can't upload firmware again. about esp8266_artnetnode_v2 HOT 11 CLOSED

My firmware doesn't use mDNS so you need to use the IP address to access it. In hotspot mode, this will be 2.0.0.1. In WiFi mode, check DMX Workshop or your router's DHCP table to find the IP.

I haven't used a Wemos before - they've got a 4M flash size so I'm not sure if that's causing an issue. I've uploaded a new binary using the 4M(3M SPIFFS) setting for you to try. Please let me know if it works.

from esp8266_artnetnode_v2.

The firmware will not run at all, its like the setting is fuct up

from esp8266_artnetnode_v2.

Yes i will trye the new Wemos D2 bin now.

from esp8266_artnetnode_v2.

Is it working? Or at least running?

from esp8266_artnetnode_v2.

Thats works, but when i give it a ip address in the setup, like 192.168.3.100 and there is no GW address to set. I can't connect to it any more.

from esp8266_artnetnode_v2.

Gateway isn't needed as we're not connecting to the internet. Make sure you've set the subnet correctly.

Also, if you're trying to change the IP for hotspot mode, it won't work. The IP in hotspot mode is always 2.0.0.1.

I haven't tested the static IP settings for a while. I'll check them later to see they are working.

from esp8266_artnetnode_v2.

I have my local network with wifi, an i normel use 192.168.x.x
And my wifi router is at 192.168.0.1 where all my computers are on.
i like the ArtNetNote to be on 192.168.3.100 and forward.
Can't i connect to the setup / config page by using 192.168.3.100 ?

from esp8266_artnetnode_v2.

Yeah you can but you'll need to setup some routing tables or static routes in your router. I'm not very good at this.

Easiest way would be to set your computer IP into the 192.168.3.x subnet.

from esp8266_artnetnode_v2.

Why not just add a gw i have 6 security cam, 3 computer, som tables, oure phones, NAS server, some other ESP devices printer and so on.

from esp8266_artnetnode_v2.

When will you release the code, so i can make it my self?

from esp8266_artnetnode_v2.

Code release will be when I do the first non beta release. I still have sACN support to add first. I will look into adding gateway for the next beta also.
This will probably be a few weeks away yet.
I am closing this issue as the initial issue is closed - I will open a new one with the gateway feature request

from esp8266_artnetnode_v2.