Python control for Broadlink RM2 IR controllers
A simple Python API for controlling IR controllers from Broadlink. At present, the following devices are currently supported:
- RM Pro (referred to as RM2 in the codebase)
- A1 sensor platform devices are supported
- RM3 mini IR blaster
There is currently no support for the cloud API.
Example use
Setup a new device on your local wireless network:
- Put the device into AP Mode
- Long press the reset button until the blue LED is blinking quickly.
- Long press again until blue LED is blinking slowly.
- Manually connect to the WiFi SSID named BroadlinkProv.
- Run setup() and provide your ssid, network password (if secured), and set the security mode
- Security mode options are (0 = none, 1 = WEP, 2 = WPA1, 3 = WPA2, 4 = WPA1/2)
import broadlink
broadlink.setup('myssid', 'mynetworkpass', 3)
Discover available devices on the local network:
import broadlink
devices = broadlink.discover(timeout=5)
Obtain the authentication key required for further communication:
devices[0].auth()
Enter learning mode:
devices[0].enter_learning()
Obtain an IR or RF packet while in learning mode:
ir_packet = devices[0].check_data()
(This will return None if the device does not have a packet to return)
Send an IR or RF packet:
devices[0].send_data(ir_packet)
Obtain temperature data from an RM2:
devices[0].check_temperature()
Obtain sensor data from an A1:
data = devices[0].check_sensors()
Set power state on a SmartPlug SP2/SP3:
devices[0].set_power(True)
Check power state on a SmartPlug:
state = devices[0].check_power()
Check energy consumption on a SmartPlug:
state = devices[0].get_energy()
Set power state for S1 on a SmartPowerStrip MP1:
devices[0].set_power(1, True)
Check power state on a SmartPowerStrip:
state = devices[0].check_power()