ksanislo / klipper-pa_cal Goto Github PK

Just a heads up: the link to the "docs" is currently dead.

Unable to parse existing variable file

[Variables]
pa_extruder_temp = 250 ; default extruder temperature
pa_bed_temp = 110 ; default bed temperature
pa_chamber_temp = 0 ; default chamber temperature (0 to disable)
pa_layer_height = 0.30 ;mm ; pa test layer height
pa_start = 0.0 ; starting pressure advance value to test (typically 0)
pa_stop = 0.1 ; ending pressure advance value to test (0.1 for direct drive, 1.0+ for bowden)
pa_steps = 20 ; number of test lines to draw
pa_between_lines = 5 ;mm ; distance between vertical lines in mm (recommended 5mm minimum)
pa_move_speed = 300 ;mm/sec ; free movement speed in mm/min
pa_slow_length = 20 ;mm ; slow line segment length (2x per line)
pa_slow_speed = 20 ;mm/sec ; slow segment printing speed
pa_fast_length = 40 ;mm ; fast line segment length
pa_fast_speed = 200 ;mm/sec ; fast segment printing speed
pa_retract_speed = 60 ;mm/sec ; retraction speed
pa_retract_dist = 0.35 ;mm ; retraction distance (0 to disable)
pa_z_speed = 10 ;mm/sec ; z movement speed
pa_accel = 5000 ;mm/sec^2 ; printer acceleration speed
pa_accel_to_decel = 2000 ;mm/sec^2 ; printer accel_to_decel speed (typically half of acceleraton speed)
pa_line_ratio = 1.125 ; line width ratio to nozzle diameter (recommended between 1.05 to 1.25)
pa_extrude_ratio = 0.885 ; filament extrusion ratio (aka flow rate, 1 if unsure)
pa_bold_extrude = 1.1 ; extrusion multiplier for bold lines, such as the frame or underline
pa_enable_frame = 1 ; print the vertical "frame" lines (1 for "yes" or 0 for "no")
pa_enable_markers = 1 ; print vertical frame markers at the speed changes
pa_marker_length = 10 ;mm ; length of markers
pa_print_values = 1 ; print the pa values after each line
pa_print_height = 4 ;mm ; font size of printed numbers.
pa_draw_underline = 1 ; draw an underline to connect all printed numbers together for easier removal
pa_underline_overlap = 0.25 ; overlap between numbers and their underline, to ensure solid adhesion
pa_precision = "%.3f" ; format string to describe decimal point precision