kismetwireless / kismet-docs Goto Github PK

Ref: https://www.kismetwireless.net/docs/devel/data_types/

Broken links "datasource docs" and "tracked component docs" in first two paragraphs point to the /docs/dev/, not /docs/devel/.

in https://github.com/kismetwireless/kismet-docs/blob/master/readme/100-webserver.md

I am following the issue kismetwireless/kismet#434 filled against kismet.

I have added a comment with an example fix

In newer versions, currently installed 201908, filter_tracker features to ignore devices not working.

Previously, this was possible in the conf file.

Old kismet.conf

Kismet supports basic filtering; networks can be excluded from tracking,
pcap logging, or general logging, based on BSSID, source, or destination
MAC addresses.

Filters, when enabled, are "positive-pass"; anything matched by the
filter will be allowed, and all other matches are excluded. To process
ONLY packets to or from the network with the BSSID AA:BB:CC:DD:EE:FF:

filter_tracker=BSSID(AA:BB:CC:DD:EE:FF)

This behavior can be inverted by using the '!' operator. To exclude
packets to or from the BSSID AA:BB:CC:DD:EE:FF:

filter_tracker=BSSID(!AA:BB:CC:DD:EE:FF)

Is there a syntax that allows the user to configure a source to channel_hop a given list of channels?
I am using an Alfa card with both 2.4 and 5Ghz range and I would like to scan only the 2.4Ghz channels.
I tried the
source=wlan0:info_antenna_type=omni,info_antenna_gain=5,channel_hop=true,channels=1,2,3,4,5,6 syntax with no luck.
I've seen older versions of the software had these type of settings documented

# Channels are defined as:
# channellist=name:ch1,ch2,ch3
# or
# channellist=name:range-start-end-width-offset,ch,range,ch,...