These are the "end cap" PCBs that attach to the +Z and -Z ends of the satellites. It's not clear what exactly we're going to put on these boards besides magnetometers; there may be more in the future?

• Cutouts for deployable antennas
• Double magnetometers.
• Single vertical 10mm tall 1.27 mm connector that plugs into the "end card" card.
  • On the End Cap: Harwin M55-6001242R 12 pin female vertical connector
  • On the End Card below: Harwin M55-7011242R 12 pin male vertical connector
• No available RF connectors.
• Slot for debug connector to pass through.

Copyright Portland State Aerospace Society 2018.

This documentation describes Open Hardware and is licensed under the CERN OHL v. 1.2.

You may redistribute and modify this documentation under the terms of the CERN OHL v.1.2. http://ohwr.org/cernohl. This documentation is distributed WITHOUT ANY EXPRESS OR IMPLIED WARRANTY, INCLUDING OF MERCHANTABILITY, SATISFACTORY QUALITY AND FITNESS FOR A PARTICULAR PURPOSE. Please see the CERN OHL v.1.2 for applicable conditions.