This is a slight modification of the Dactyl-ManuForm, made for use with Nice!Nano using ZMK firmware. The layout used is also Nordic, so some modification might be needed.

3D-prints used are in the prints/ folder.

The board has been soldered using the same layout as the original Dactyl-ManuForm, using the corresponding pins on the Nice!Nano. To make it easier to change the switches, I have soldered the wires to hotswap sockets instead of directly to the switches.

• Nice!Nano v2 (one for each half)
• LiPo batteries
• 1N4148 Signal Diodes
• M3x5.7x5.0 Heat inserts for 3D-prints.
• M3x10mm screws.
• Kailh hotswap sockets
• Gateron Phantom Browns (any cherry like switches will do)
• Some keycaps
• Time and patience.