Custom firmware for the Toniebox WIP

This firmware is dropped for favour of the new HackieboxNG Custom Firmware project

The custom bootloader is fully functional. The hackiebox custom firmware itself isn't ready as daily driver yet.

• Custom (sd) bootloader
• Hardware drivers (WiFi, AMP/DAC, RFID reader, accelleration sensor, battery/charger, SD, LEDs)
• Webinterface with basic CLI and file upload/download
• JSON configuration file
• Battery stamina test with csv log
• Tonie file header decoder
• WAV player (with cli + by wav file in /rCONTENT//)

• Configuration of the WiFi credentials via a WiFi Hotspot
• Optimize "Threading" to play WAV without stuttering
• OPUS decoding / playing tonie files
• MP3 decoding (or other formats)
• Remote WiFi speaker (chromecast or similar)
• Custom (sd) bootloader that allows context sensitive firmware image switching for more complex features that don't fit into a single image
• Bootloader: Allow dynamic target address to allow direct starting of the OFW.
• Bootloader: Dynamic patching of loaded firmwares by an addtitional file.
• Overcome limited include path of Energia
• Set up buildchain without Energia / micropython dependencies

• WiFi configuration is cleared and replaced with the credentials from the json config

Currently building only works with Windows. Linux doesn't work on a x64 only system. You should prepare the toniebox with the sd bootloader to load the cfw from your sd card.

Please install the latest Energia release (1.8.10E23 tested).

In addition you need to install the cc3200 board library.

Replace the cc3200 board library files with the toniebox-cc3200-core and restart energia. The folder with the boards packages are located at:

%LOCALAPPDATA%\Energia15\packages\hardware\

~/.energia15/packages/energia/hardware/

~/Library/Energia15/packages/hardware/

SimpleCLI ESP8266Audio ESP8266SAM

Open hackiebox_cfw.ino with energia and build the cfw. Remember the path where the hackiebox.ino.bin is saved. Usally you find it at C:\Users\<User>\AppData\Local\Temp\arduino_build_XXXXXX.

It is recommended to have a second copy of the cfw to be able to load the working image and update a broken cfw image over your backup cfw.

First of all you need to create "/revvox/web" on your sd card (subdir revvox should be already there if you have successfully installed the sd bootloader) and copy over the content of the /web/ directory of this repository. In addition you have to copy your cfw image to your selected slot(s) on the sd card. (ex. "/revvox/boot/pre-img1.bin")

Reinsert the sd card and run the cfw once. Then shutdown the box again (put the box onto the front where the speaker/tonie logo is and press both ears for 10s). Then remove the sd card again and add your wifi credentials to the created "/revvox/hackiebox.config.json" config file.

To update the firmware ota you can just use the hackiebox website und the box' ip address. (Expert->File Upload).

Keep in mind that connecting the RX Pin of the box to a serial interface blocks the big ear. For reading the log messages it is enough to have the TX Pin only connected (beside GND). Trello Hackiebox Dev Board