ichilton / nanode Goto Github PK

Hey,

First of thank you very much for the guide, it's really helpful to have an updated one so I didn't have to work from the one made for the previous version!

It might be just me though, but I'm really confused by the last part of the build guide :(

I have a Nanode Classic kit – effectively an RF without the actual RF part as it seems – and I can't work out what do I need to do towards the end when building it from the RF guide. When trying to measure I get 0-0.1V and I'm not sure if it's my dodgy soldering or I missed a part.

How do people debug soldering anyway? Are there some alternative legs / pins to check where the problem is?

Anyway, the bit I'm the least sure about is if I need to do the voltage selection and capacitor fix bits even if not using RF?

To give something back too, I was making photos while building so can contribute the missing step 7 and the alternative order with IC sockets soldered after step 12. Do you want me to upload these photos on my Flickr and send a pull request with them edited in or should I send the photos to you directly?

Also, I found that it's much easier to solder the reset switch straight if the protruding bit near the resistor is snipped off, might be worth mentioning in the guide.

hi, i'm trying to get these files from solderpad but they are not there due to an gateway error

openenergy does not sell them anymore

where can i get hold of the files so i can thinker with them?