Hi Sir HDR

The Ique dookie project is the clones of ique card,right?

i had download Dookie Gerber and Sch but can't open it by CAM350 and Protel99, what PC tool can open it?

the process how to clones ique card in my understand,am i right?
1.dump original NAND from original ique card
2.build Dookie PCBA
3. upload original NAND file to Dookie PCBA

I had the board made with a thickness of .8mm at OSH Park. For the LE26FV10NITS-10 save flash, the pad spacing is just large enough and it had to be very carefully aligned and was a bit difficult to flow solder since the pads were not pretinned, but ENIG plated.

I soldered the save flash, mask ROM, and capacitors of Super Mario Advance 4 and it did not boot. The mask ROM is AX4E-0. Have you tested this design?

Hi,

It appears that in both the schematic and pcb for the DMG-KFDN-01 project, C4 and C5 are connected together, but that connecting net is not connected to ground.

Looking over the PCB pictures here:

https://gbhwdb.gekkio.fi/cartridges/DMG-APAU-0/mattcurrie-1.html

It appears that the ground connection is there, similar MBC3 boards appear to have the same connections for the SRAM.

Thanks,

Mike

In this example, I am looking at the pads of U1 on the AGB-E02-20 PCB. I am wondering if there is any particular reason that the pads are all three pads strung together instead of one pad. I am looking to submit a PR that corrects this, but before I do so I wanted to check if this was the intended design.