gudnimg / bcm-hv Goto Github PK

Some data can only be read if Page data byte is 0x00 or 0x01

• Usage
• How to BCM module is connected

• convert_raw_vin() - HI-side voltage
• convert_raw_vout() - LO-side voltage
• convert_raw_iin() - HI-side current
• convert_raw_iout() - LO-side current
• convert_raw_rout() - Low-voltage side output resistance
• convert_raw_temperature() - Internal temperature
• convert_raw_k_factor() - K factor
• convert_raw_ton_delay() - Start up delay in addition to fixed delay

• LO-side output resistance
• K factor
• Internal Temperature

Gets the actual time in seconds. May be useful in debugging the soft start time.

Gets the actual Input current at the HV side with unit A.

Currently I wrote it with big endian

Gets the actual Input voltage at the HV side with unit V.

Also allow user to send one byte as input without having to cast it as a pointer type.

Gets the actual K factor.

I'm not sure if this number stays constant or if it changes. Implement this and find out.

Gets the actual resistance of the low voltage output in unit Ohms. This is done using the command READ_BCM_ROUT

Gets the actual output voltage at the LV side with unit V.

Gets the actual internal temperature within the BCM module with unit °C.

The format is giving below.

It would be better to just send two bytes instead of sending first the command byte -> then a repeated start condition -> then data byte.

Gets the actual output current at the HV side with unit A.