grblhal / plugins_laser Goto Github PK

I have my home built laser running with the iMXRT1062 Driver. I wanted to try out PPI, but not sure how to get it going in light burn. Would it be possible to try your version of the iosender for your laser?

Hi, i have problem (as always :) ).

So i generate gcode in LB with clusters under Smoothieware device preset, but i cant test it out.
LB is not communicating with grbl if i set Smoothieware device.

When i try to load it to iosender, i need to check every row by pressing OK

[VER:1.1f.20220928:]
[OPT:VNMSL,35,1024,3,0]
Target buffer size found
[AXS:3:XYZ]
[NEWOPT:ENUMS,RT+,REBOOT,TC,SED,RTC]
[FIRMWARE:grblHAL]
[NVS STORAGE:*FLASH]
[DRIVER:ESP32]
[DRIVER VERSION:220922]
[DRIVER OPTIONS:v4.3.4]
[BOARD:MKS DLC32 2.0]