This repository contains 3d Benchy prints and their associated klipper configurations and slicer profiles. Major changes to the slicer settings or klipper configuration will be denoted by a release including the binaries for both. Both printers are running Klipper firmware attached to a Raspberry pi. I use Fluidd for an interface

Gifted to me by my best friend Aaron Cleveland (@notyourswiftdev). He gave it to me with a BL Touch

• Bed: Borosilicate glass bed
• Hotend/Extruder: Microswiss direct drive
• Z Axis: dual, no timing belt

• Tramming/leveling is difficult due to the X-axis being misaligned.
  • A timing belt across the dual z-axis may help, but I fear one or both of the rods may be bent.

I bought this as a gift to myself after being hired on at Nautilus

• Hotend/extruder: S1 pro (awaiting delivery)

• There's an issue with the extruder/hotend being misaligned/skewed which sometimes causes it to crash into the bed because the right side comes into contact prior to the sensor coming into contact with the bed.
  • The crashing doesn't cease unless the machine is powered off (the nozzle continues trying to lower).
  • This issue caused me to fiddle with the extruder a little too much and I've turned the adjustment screw past the point of no return. RIP extruder