This is the basic building block for having a mapserver. First integrating yanic and allowing it to runon docker-enabled hosts.

Ensure that the multicast traffic is leaving the node through the correct interface. For example, if mmfd0 is to be used:

ip -6 r add ff05::2:1001/128 dev mmfd0 table local

Build The Container

docker image build -t yanic .

Then run the container:

docker run -d -p 8080:8080 --name=ffmd_yanic -v /etc/config.toml:/etc/yanic.conf:ro--network host yanic

:-D

This is free software under the BSD-2 license