Wrong Image Format for bootm command about u-boot-fslc HOT 3 CLOSED

Please report this to Freescale Community; you should check how we do this in Yocto as it is already solved there.

Otherwise I can offer you our support services were we can help you directly.

from u-boot-fslc.

Thank you very much, Otavio. I am already create post here https://community.freescale.com/message/354562#354562
but I have no eny reply.
I am going to use Yocto as you advice.
Can you rovide me some howto or manual about Yocto?

Regards

from u-boot-fslc.

Hi,
i am new to imx6 board and i am facing the same issue mentioned above

U-Boot 2013.10-Q7-QD-256MBx446)

CPU: Freescale i.MX6Q rev1.2 at 792 MHz
Reset cause: POR
Board: SECO Q7
I2C: ready
DRAM: 1 GiB
Boot: Ext SD
MMC: FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2
*** Warning - bad CRC, using default environment

In: serial
Out: serial
Err: serial
Net: using phy at 6
FEC
Hit any key to stop autoboot: 0
mmc0(part 0) is current device
** File not found /boot/uImage **
Wrong Image Format for bootm command
ERROR: can't get kernel image!
MX6Q SECO_Q7 U-Boot >

above is the u-boot log i abtained through debug seral poart in minicom .
can any one help me with this issue .
@aleksandrm8 wanted to know did this work with yocto if yes can you send me the steps plz

thanks in advance.

from u-boot-fslc.