Control your remote power sockets with a raspberry pi. This project includes a web interface.

• sui li for creating RCSwitch for the arduino
• r10r for porting RCSwitch to the raspberry
• x3 for creating homecontrol4me

• Raspberry Pi
• 434 Mhz transmitter
• Some radio controlled power sockets

• Install wiringPi. See https://projects.drogon.net/raspberry-pi/wiringpi/
• Checkout this project
• Compile it
• Connect pin11 of the raspberry to the transmitter

Try if all is working with the send program

• Switch on single socket: ./send.cpp 00001 1 1

Pass the -b-option to use binary socket numbering instead of the common "only one switch up"-numbering. See Binary Mode for further details.

Most sockets available for purchase use the following numbering scheme:

Of course, this doesn't make much sense, because it limits the maximum of supported sockets to 5 (or 6, if 00000 is included), and is less intuitive. Using real binary numbering would increase the limit of supported sockets per system to 31, and be more intutive. In binary mode, the sockets need to be numbered as below:

Note that you need to configure your sockets to this kind of numbering to use this feature. This often includes that the dedicated remote that gets shipped with the sockets often is rendered useless, since it only supports the former way of numbering.

Use the daemon in combination with the webinterface

• Copy the files in webinterface in your http directory
• Edit ip address in config.php
• Edit the predefined setup of sockets in config.php