A breadboard-friendly ESP12E/F breakout with all I/O pins available, flash/reset buttons onboard, and place to directly use it with FTDI modules like FT232RL FTDI Serial Adapter Module.
| Top View | Bottom View |
|---|---|
 |
 |
| No | Component | Quantity |
|---|---|---|
| 1. | ESP8266 - 12e/f | 1 |
| 2. | 10KΩ 0805 smd resistors | 5 |
| 3. | SMD-SWITCH-6.2MM | 2 |
| 4. | Pin Header 1x11 Male 2.54 mm | 2 |
- If you want to power up ESP8266-Breakout directly from a FTDI board, you need to solder the jumper that exists on the bottom side of the ESP8266-Breakout. IMPORTANT: Do not forget to change the jumper to 3.3V instead of 5V, on the FTDI module.
- If you want to use ESP8266-Breakout with a breadboard.
- Connect Vcc to 3.3V
- Connect Gn to Ground
- You do not need to connect EN pin (ESP8266-Breakout itself has the required connection)
- You do not need to add any extra pull-up or pull-down resistors on GPIO15, GPIO2 or GPIO0 for Boot Mode Selection
This project was developed using free version of EAGLE 9.5.2
Gerber files are available here
React
Typescript
Django
Laravel
Facebook
Microsoft
Google
Alibaba
D3
Tencent