A custom acrylic, laser cut computer case for a mini-ITX motherboard, SFX power supply and RTX 3090 FE.

This was created using C and output to an SVG to be laser cut. You can easily change parameters within the code to adjust all aspects of the case.

Note, you will need:

• A Laser Cutter
• A little more than 24x18" of 3/4" (8.5-9mm) acrylic.
• 6x #6-32 3/4" bolts, 6 #6-32 nuts.
• A lot of M3 hardware.
• A 144 LED/meter right-angle LED strip. (You'll need 72 LEDs)

Included for convenience is the SVG from my code.

Run this with the following command:

tcc -run gen_svg.c > case.svg