bruceroyce / ultimatereprappost Goto Github PK

Hi, thanks for your post pro !
Is that possible to upload your config.g
Because I tried with my config and when a T occur I'm not able to change my spindle speed.

Thanks !

Hey there,

This is great, but I have the same problem as I do with all the the Fusion post processors in that it tries to do the first move into position without lifting the spindle.

Once it gets to the first ramp down position, it moves the spindle up, but it's already too late as it's crashed into the stock on the move and snapped the end mill.

Ideally every job should start but moving the the spindle to Z maximum before moving anywhere so it can clear any clamps etc.
I can do this manually by editing the and inserting the appropriate move command just before the first G0, but its easy to forget and a bit of a PITA.

How can it be set to move start the whole job (and any moves after a tool change) by first moving the spindle up and out of the way of the stock and clamps.

Thanks.

Is there any way to change some of the default output? I would like a way to change the beginning and ending code. Especially for the alerts and the ending movement after a job is complete. I'd also like to use some of the object model data.

It would be nice not to hand edit the same thing each time.

Otherwise it's the best post I've found for the Duet.