enderwire_nonpro's Introduction

enderwire_nonpro

This is a collection of parts to fit the Gizzle Y-Axis for the Standard Ender with 2040 Y Extrusion to fit the DarkDog Rev2 Ender_SW.

Based on Gizzles Y-Axis https://github.com/VoronDesign/VoronUsers/tree/master/printer_mods/Gizzle/ender-3_(pro)_switchwire

And DarkDogs Rev2 https://github.com/boubounokefalos/Ender_SW/tree/Rev.2

There are mounts for the original PSU, the thick non-meanwell one. It is advisable to not use a lower panel then (or create a cutout), as the psu fan is very close to the panel.

Overview of changes:

Y-axis extrusion moved forward with replacing the M5 bolts with shorter ones and using t-nuts in the extrusion. 35mm bolts are bit too long depending on how the extrusions are machined, so use some washers under the bolt head till the bolts does not hit the bottom of the extrusion.
Modified Skirt to hold PSU, added Parts when using original PSU.
Modified Rear Grill to have some room (a few Millimeters) for belt tightening.
Located of Pi to the front.
Connected front idler mount to frame.
There is no belt tensioner, use the rear motor mount to tension the belt (Same as Switchwire)

Part	Original	Replace with:	Comment:
Parts form Y-Axis Gizzle Repo
Y-Axis Front Idler	Y-Idler-Bottom	y_idler_lower_part and front_y_grill_connection	Adds a connection to the Front Grill
Parts from DarkDogs (boubounokefalos) Rev2
Grill	rear_grill_middle	rear_grill_middle_nonpro
Extension/Side Skirt	rear_extention_left_a	rear_extention_left_a_psu	Also replaces the PS_4040_Slide_Mount as mount for the psu
Deck Upper Side	deck_upper	deck_upper_non_pro	Also available as dxf
Rear Panel	rear_panel	rear_panel_non_pro	Also available as dxf
If using the original thick PSU:
PSU Mount	PS_4040_mount_x2	2x orig_psu_mount
Extension:	rear_extention_left_a	extension_left_a_orig_psu