bobricius / armachat Goto Github PK

Good afternoon, do you have instructions for beginners to install software for armachat and picocomputer? based on pi pico.

Following your youtube video for the build you first copy over a file called "first.uf2" however this file has never been committed so guess this file has been replaced with the "Firmware.UF2" file? At any rate I have tried all the firmware's that have been committed but my fusion 3 appears to be stuck in some sort of loop, the screen is white and illuminated but the backlight repeatedly turning on and off (not the breathing animation) and if I connected it to my pc the windows USB notification sound plays repeatedly. Any help you can provide would be greatly appreciated.

Arduino IDE log:
Sketch uses 43176 bytes (17%) of program storage space. Maximum is 253952 bytes.
Atmel SMART device 0x1001000a found
Device : ATSAMD21E18A
Chip ID : 1001000a
Version : v1.1 [Arduino:XYZ] Jul 14 2020 23:30:13
Address : 8192
Pages : 3968
Page Size : 64 bytes
Total Size : 248KB
Planes : 1
Lock Regions : 16
Locked : none
Security : false
Boot Flash : true
BOD : true
BOR : true
Arduino : FAST_CHIP_ERASE
Arduino : FAST_MULTI_PAGE_WRITE
Arduino : CAN_CHECKSUM_MEMORY_BUFFER
Erase flash
done in 0.871 seconds

Write 43840 bytes to flash (685 pages)
[==============================] 100% (685/685 pages)
done in 0.283 seconds

Verify 43840 bytes of flash with checksum.
Verify successful
done in 0.072 seconds
CPU reset.

Device resets and then it's all black. Nothing is happening.

Any way to increase the range to the LoRA limit of 3 miles city/5 miles rural?

Is the current limit of 500 meters because of the component you're using or to conserve power?

Thanks

As I can see, only the desktop version PCB is in this repo. Could you also publish the pocket version PCB?

Hey there, see that you made some headway a couple years back on implementing Meshtastic on armachat, but the thread went silent. Curious if you hit any hardware configuration issues, and if not if you would be willing to push your progress in a branch on this repo or in a new repo for contributions.

Hi,

Do you have a BOM with references directly usable on digi-key or farnell for example?

I tried to open these files but none of them are recognised by any software I have that uses these extensions (.blend, .sch & .dxf).

hello! this project is beautiful and i want to learn SAMD21E18, i would love your pcb, could you publish it? i saw that there are only very old versions, i don't want it is not supported anymore! i think many of us would be happy :D
thank you for your work!

Hi there,

I’m rather new to the world of iOT. I purchased a couple of Doomsday Communicators and both of the devices recently stopped booting. The red power light stays solid and the green ACT light goes solid and then flashes 7 times. I guess that means that the kernel.img is not found (https://www.partitionwizard.com/partitionmagic/raspberry-pi-not-booting.html)? What files would you recommend I install from your GitHub post? Many thanks!