This is the Visor_frame_SWEDEN_v10.stl from Faceshield.nu devided into two parts for printing on the Makerbot Replicator 2.

We have produced 3d visor using the orginal model. To increase the production, we modified the original model to be able to fit it on a small build plate. The visor is printed in two parts and snapped together.

More images and a short assembly movie can be found in the media folder.

The model may not be suitable for strict demands and environments such as hospitals, instead use the the orginal from Faceshield.nu.

Printing settings in Autodesk Print Studio
Draft
Layer height: 0.3mm
Number of perimeters: 2
Sparse infill defnsity: 5%
Sparese infill pattern: Rectillinear
Enable raft: True
Estimated printing time: 1h 37min

The printing takes forever and the model may need adjustments for other 3d printers.

We ended up NOT using this model.

1. It takes a lot of time.
2. It has more places that can be harder to clean.
3. Without a heated build plate, wrapping occurs and the printing sucess rate drops.
4. The original model works!

I was asked to share this model to support others wanting to create visors for small printers. Here it is - with issues descibed too.