The buttons stop temp basal and resume/suspend delivery should be separated. Stop temp basal should be another button.

The behaviour of the button is the same as stopping the temp basal.

You need to press it twice before the view changes although the pump receives the command already the first time. Sometimes the button hangs, so you need to repeat the procedure again with two times pressing the button.

This might be a symptom of running with the dana-simulator.

DanaKit commit: 91da900
LoopWorkspace dev + Dana using loopandlearn GitHub username:

• https://github.com/loopandlearn/LoopWorkspace/tree/dev_dana

dana-simulator commit: 22b8f69 running on a rPI 4.

When I tapped on Sync Pump time, the app crashed. See graphic:

My basal schedule stored in the Loop settings was stored in profile B. Usually, loop only uses one profile, e.g. profile A.

It took three attempts to store the basal schedule in the pump- I had to adjust the basal rates to trigger the storage.

It would be nice to have a notice when it# acjnologed that the basal schedule is stored.

If you store the delivery speed, at let's say 60 sec/U, it switches to 12 sec/U, so you need to repeat it every time before blousing. The automatic bolus is very fast therefore.

If you want to stop the temp basal, you need to press rhe button twice. The pump receives the command after the first time, but the button remains in the stop basal state.