After following the short guide i tried plugging my BPI-M3 into my pc and powering it on but nothing seems to happen, here are the commands i ran before putting my sd card into the BPI-M3 and the output of them

sudo gunzip -c ./ArchLinuxARM-BPI-M3-11-20-2018.img.gz | sudo dd of=/dev/sde

dd: writing to '/dev/sde': Input/output error
460529+0 records in
460528+0 records out
235790336 bytes (236 MB, 225 MiB) copied, 192.248 s, 1.2 MB/s

sudo fsck.ext4 -v /dev/sde

.....
Fix? yes

Directories count wrong for group #20 (82, counted=0).
Fix? yes

Free inodes count wrong for group #32 (1889, counted=8144).
Fix? yes

Directories count wrong for group #32 (843, counted=0).
Fix? yes

Free inodes count wrong (416662, counted=457556).
Fix? yes

Padding at end of inode bitmap is not set. Fix? yes

Recreate journal? yes

Creating journal (16384 blocks):
Done.

*** journal has been regenerated ***

BPI-ARCH: ***** FILE SYSTEM WAS MODIFIED *****

   14796 inodes used (3.13%, out of 472352)
     100 non-contiguous files (0.7%)
       9 non-contiguous directories (0.1%)
         # of inodes with ind/dind/tind blocks: 0/0/0
         Extent depth histogram: 13898/36
  255697 blocks used (13.55%, out of 1886976)
       0 bad blocks
       1 large file

   12549 regular files
    1384 directories
       0 character device files
       0 block device files
       0 fifos
     163 links
     854 symbolic links (853 fast symbolic links)
       0 sockets

   14573 files

Запускал сборку на Bpi-m3 с фирменным экраном от SinoVoip, не работает. Курил мануалы по device tree пока не раскурил как включить ЛСД дисплей. Можете решить эту проблему , пнуть в правильном направлении или можем попробовать решить эту проблему совместными усилиями? Моя Почта для связи [email protected]