Imported Assemblies/Parts don't render the same draw style about freecad_assembly4 HOT 2 CLOSED

Some digging around and I may have found this to be an issue across FreeCAD as a whole.
https://forum.freecad.org/viewtopic.php?t=70439&sid=024be3b3e9fb58458fe19dc515e4e331

from freecad_assembly4.

I have found a solution. Not sure if this is the devs' intended way of doing this, but it works so I will close this issue.
In the following image, the 4040 extrusion and the two cylinders are from another file. All files are currently in "As is" draw style.

This image shows original issue. Going from "As is" draw style to "Wireframe" in active file only.

This image shows the issue resolved by changing the view settings of the linked object. Specifically changing the "Display Mode Body" from "Through" to "Tip".

Changing the "Display Mode Body" resolves this issue entirely and doesn't require the linked parts' original file to be fully opened. This solution is less tedious than opening files, but still requires each different linked object's view settings to be switched. I hope this helps any users that encounter this.

from freecad_assembly4.