strange "peaks" in S11 after upgrading to 0.2.1 and higher about nanovna HOT 6 CLOSED

Installed the 0.2.3 and tested with actual Version of nanoVNA-saver. It seems the problem is solved. Thank you! :)

from nanovna.

I can't reproduce this issue. Just updated from 0.1.1 to 0.2.2 and the response of a filter is the same in both versions.

from nanovna.

cannot reproduce, but I tested it with NanoVNASharp. May be this is nanoVNA-saver issue

from nanovna.

Have here "strange" Peaks after upgrading to v0.2.1. v0.2.2 shows same behaviour. Took Screenshots with nanoVNA-saver to show the Problem. The v0.2.0 from 27. Sept. seems ok.

are You using multiple segments in nanovna-saver ?
I have similar Peaks, but only in nanovna-saver with multiple segments.

from nanovna.

Yes, its occured only in Multi-Segment Mode.

from nanovna.

This issue is caused by behavior change of sweep command at 0.2.0.

This commit 3fc17e1 shall make equivalent to former behavior. When I tested NanoVNA-saver 0.1.0 in multisegment mode with new firmware, it works well.

New release 0.2.3 is available including commit above.
Could you check it out?

from nanovna.