Teensy LC/3.2 about tspislave HOT 5 CLOSED

Just an update, when setting pins to 11-14 and SPI[x] to SPI, I get the following error:
`C:\Users\Andrej\Documents\Arduino\libraries\TSPISlave-master\TSPISlave.cpp: In member function 'bool TSPISlave::setSlaveSCK(uint8_t)':

C:\Users\Andrej\Documents\Arduino\libraries\TSPISlave-master\TSPISlave.cpp:199:5: error: 'CORE_PIN32_CONFIG' was not declared in this scope

 CORE_PIN32_CONFIG = PORT_PCR_MUX(2);

 ^

Error compiling for board Teensy LC.`

from tspislave.

yeah theres one ifdef i forgot to add but it does work on T3.2/LC, i’ll try to patch it tomorrow, this is because i worked on SPI1/2 after the 3.2/LC was tested

from tspislave.

OK, thanks. I will test it next week if I have some time.

from tspislave.

just updated the library to support parallel running of TSPISlave.h and and SPI.h, in case the user who has more than 1 SPI interface can use both master and slave modes together.

Also defined the pins for T3.5 / T3.6 to not cause compile error when compiling for Teensy 3.2/LC

Also keep in mind the SPI interface of LC is max 6MHz and does not mean it will work that far, results have tested around 4-5MHz should be fine. The SPI1 interface on LC can run at 12MHz slave mode, 11MHz was tested in the past

from tspislave.

Thanks, compiles OK for both 3.2 and LC.

from tspislave.